REQUEST INFORMATION
REQUEST INFORMATION

Demagnetizer Table Top

These Demagnetizers are the models most used in any workshop where it is necessary to remove residual magnetism from parts machined on magnetic or electromagnetic plates.
Description

Instructions for correct use of Demagnetisers:

Place the part that is to be demagnetised on the demagnetiser, connect it and drag it over its surface until it is 30 cm from the demagnetiser. Then without bringing the part close to the demagnetiser, disconnect it. If the part is not totally demagnetised, repeat the same steps.

These demagnetisers are for intermittent use. They should not be connected for more than 10 minutes. They have an incorporated thermostat which disconnects them when they reach the maximum admissible temperature.

desmag_sobrem

Standard Measurements Listings:

Code A (mm) B (mm) C (mm) Intensity (A) Power (V.A.) Weight(Kg)
ACCD01422 160 120 115 1.3 286 5.5
ACCD01423 220 170 122 3 660 12
Web desarrollada por 
Volcanic Internet
Info
magnifiercross